Tensioning The Saw Chain (Side Chain Tensioner); Tensioning The Saw Chain (Front Chain Tensioner) - Stihl MS 210 Manual De Instrucciones

English
N turn the adjusting wheel (4) a little
until the chain sprocket cover can
be slid completely against the
engine housing
N Swing grip (5) into position (until it
engages)
N Fit wing nut and tighten lightly
N Next step: see "Tensioning the Saw
Chain"
28
Tensioning the Saw Chain
(side chain tensioner)
1
Retensioning during cutting work:
N Shut off the engine.
N Loosen the nuts.
N Hold the bar nose up.
N
Use a screwdriver to turn the
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
N While still holding the bar nose up,
tighten down the nuts firmly.
N Go to "Checking Chain Tension".
A new chain has to be retensioned more
often than one that has been in use for
some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions".
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
Tensioning the Saw Chain
(front chain tensioner)
1
Retensioning during cutting work:
N Switch off the engine.
N Loosen the nuts.
N Hold the bar nose up.
N
Use a screwdriver to turn the
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
N While still holding the bar nose up,
tighten down the nuts firmly.
N Go to "Checking Chain Tension".
A new chain has to be retensioned more
often than one that has been in use for
some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions".