Mounting The Bar And Chain (Quick Chain Tensioner) - Stihl MS 210 Manual De Instrucciones

English
1
3
1
2
N Fit the guide bar over the studs (1) –
the cutting edges on the top of the
bar must point to the right.
N Engage the peg of the tensioner
slide in the locating hole (2) –- place
the chain over the sprocket (3) at
the same time.
N Turn the tensioning screw (4)
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
N Refit the sprocket cover and screw
on the nut only fingertight.
N
Go to chapter on "Tensioning the
Saw Chain"
26
Mounting the Bar and
Chain (quick chain
tensioner)
4
Removing the chain sprocket cover
N Swing grip (1) into position (until it
engages)
N Turn the wing nut (2) to the left until
it hangs loosely in the chain
sprocket cover (3)
N Remove chain sprocket cover (3)
Mounting the tensioning gear
N Remove and reverse tensioning
gear (1)
1
3
2
1
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
2
N Remove screw (2)
1
N Position tensioning gear (1) and
guide bar (3) relative to one another
2
N Insert and tighten screw (2)
3