Fiamma F80s Instruciones De Montaje Y Uso página 17

9 - MOTOR PROGRAMMING
EN
Once the Motor Kit is installed and verifi ed that the operating voltage is 12 V (not higher),the Motor Kit
F80 S Plus can be operated either with the button or with the remote control, both devices are supplied
with the motor. The Motor Kit is equipped with an automatic system that allows the fabric to tension
itself once it has been opened completely.
Self-tensioning: when the fabric is completely unrolled, it retracts for a preset time, so that it tensions
up. The Motor Kit can be installed on awnings with different fabric extension (related to the length of the
awning), thus the automatic system must be "set" beforehand.
CONTROL UNIT PROGRAMMING
Through this procedure the system recognises the complete extension of the awning fabric and
automatically defi nes the self-tensioning, visible the next time it is opened. The self-tensioning of the
fabric only works when the awning is opened.
For this operation, perform the following steps:
• Disconnect the 12 V power supply to the control unit
• Press and hold the EXTEND button
• Restore the 12 V power supply; after about 10 seconds the awning will start to open
• When the awning is fully open, or has reached the maximum extension of the fabric, release the
EXTEND button
• Wait at least 10 seconds or, if installed, for the LEDs to turn off, then press and hold down the
RETRACT button until the awning is completely closed.
• The awning is ready for use.
USE WITH BUTTON (AUTOMATIC MODE)
Opening:
• Press the EXTEND button for less than 2 seconds
• The awning will open at the maximum extension of the fabric, making the self-tensioning (in
automatic mode, when opening, it is always active)
Closing:
• Press the RETRACT button for less than 2 seconds
• The awning will close completely
Note: the duration of automatic opening is timed and does not take into account the position of the
lead bar; if the lead bar is already open, opening in automatic mode will take place for the preset time.
USE WITH BUTTON (MANUAL MODE)
Opening:
• Press the EXTEND button for more than 2 seconds
• The awning will open until the button is released (by releasing it, the engine stops). In this mode the
self-tensioning is not active
Closing:
• Press the RETRACT button for more than 2 seconds
• The awning will close until the button is released (by releasing it, the engine stops).
Note: opening the awning in manual mode up to a certain extension, stopping it and then restarting in
automatic mode, the opening in automatic mode will take place for the preset time.
USE WITH REMOTE CONTROL
• Before using the remote control, connect the sensor to the control unit (Fig. 10-13) and remove the
protective fi lm from the remote control (Fig. 14).
• The remote control only works after programming the control unit.
• Press the EXTEND or RETRACT button to open or close the awning in automatic mode only.
OPENING OF THE AWNING
Perform the operation in two people, taking care to accompany the front of the awning during the
opening (being a non-self-supporting arm awning, it should never be opened without supporting the
lead bar).
Once the fabric is completely open and pretensioned, lower and adjust the legs as shown in the fi gure.
If the opening operation cannot be carried out by two people, open the lead bar by about 1 metre and
lower the legs to support the lead bar itself (as shown in the fi gure); proceed progressively until the
awning is fully extended.
FIAMMASTORE
17