HP Latex 115 Información De Introducción página 14

Error code
32:01.1, 32:01.2
32:02
41:03
42:03
63:04
12 HP Latex 115 and 300 Printer Series
Recommendation
This error occurs when the tension bar stays in one of its sensor trigger positions for
more than 8 seconds. The most likely causes of this error are as follows:
The winding-direction switch on the take-up reel motor is activated, but
●
substrate has not been taped to the take-up reel yet.
The wrong take-up reel winding direction has been selected.
●
Something is blocking the movement of the tension bar.
●
The substrate is not following the correct path between the tension bar and
●
the diverter.
This error occurs during printer initialization, to warn you that the take-up reel has
been disconnected while the printer was turned off. It also occurs if you try to enable
the take-up reel, but it is not connected to the printer. Connect the take-up reel to
the printer and tap OK to continue.
Electrical current limit in paper motor.
1. Turn off the printer.
2. Open the window and check for any visible obstacles restricting the advance of
the substrate. If there is a wrinkled mass of substrate inside the substrate
path, lift the substrate pinch lever and clear the obstruction. Carefully remove
as much as possible of the jammed substrate from the top of the printer. Cut
the substrate if necessary.
Try to avoid pulling the substrate out from the input path, because
CAUTION:
this reverses the normal direction of movement, and could damage printer
parts.
3. Turn on the printer.
Scan-axis motor electrical current limit.
1. Turn off the printer.
2. Open the window and check for any visible obstacles restricting the advance of
the substrate. If there is a wrinkled mass of substrate inside the substrate
path, lift the substrate pinch lever and clear the obstruction. Carefully remove
as much as possible of the jammed substrate from the top of the printer. Cut
the substrate if necessary.
3. Turn on the printer.
An input/output problem has occurred in the network card.
1. Make sure that the network cable is correctly connected to the network card.
2. Check that your printer firmware is up to date.
ENWW