HP Latex 115 Información De Introducción página 15

Error code
63:05
68:03
74:01
78:08
78.1:04
78.2:01
79:03, 79:04, 79.2:04
81:01, 81.1:01, 81:03
ENWW
Recommendation
The job is reaching the printer too slowly. The printer cancels the job if there are long
pauses of more than 20 s.
1. Make sure that a 1 Gigabit Ethernet card is correctly installed in the computer
with the RIP.
2. Check the RIP for any error messages. Check that the computer with the RIP is
working correctly and has the minimum specification required by the RIP.
Check that the hard disk is neither full nor excessively fragmented.
3. Check whether the option RIP while printing is enabled. This option can cause
slow printing if the computer is not sufficiently powerful.
4. Try reducing the resolution of the job or increasing the number of passes.
5. Check that all the components of your LAN are operating at Gigabit speed.
There has been a loss of permanent data, such as configuration or accounting data.
This can happen after a firmware update with a data structure not compatible with
the older version.
An error occurred when uploading the firmware update file.
1. Turn off the printer by using the power key on the front panel and the power
switch at the rear of the printer. Disconnect the power cord, then reconnect
the power cord and turn on the printer.
2. Try again to upload the firmware update file to the printer.
Borderless printing is not possible. If you have an HP Latex 375/365 Printer, install
the ink collector accessory.
The printer has no substrate preset for this substrate. Follow the firmware update
procedure to update the printer with the latest substrate presets.
The back tension is lost. This could be due to a loose roll core or an imminent end of
roll. If these are not the causes, try unloading and reloading the substrate.
Generic firmware error. Update the printer's firmware.
It was impossible to stop the servo correctly before setting the encoder position.
1. Turn off the printer.
2. Open the window, observing all safety procedures, and check for any visible
obstacles restricting the movement of the drive roller. If there is a wrinkled
mass of substrate inside the substrate path, lift the pinchwheels (using the
substrate lever) and clear the obstruction.
3. Turn on the printer.
Front-panel error codes
13