EGAmaster 79760 Manual De Instrucciones página 48

- For larger pipe diameters, it is necessary to use a second guide carriage with an
additional tensioning chain (see fig. 3.8).
4. Put the drive unit onto the guide carriage and fix it with the ball lock bolt Ø12 mm (see fig.
4.1 respectively fig. 4.2).
- Swing up the drive unit and screw the adapter (see fig. 4.3) on the shaft. Tighten the
adapter with the single head wrench AF 17 and 24.Then fix your appropriate cutting tool by
using the single-head wrench AF 24 and 32 (see fig. 4.4, 4.5 and 4.6).
48