EGAmaster 79760 Manual De Instrucciones página 58

SAFETY INSTRUCTIONS FOR PREVENTION OF PROJECTILE HAZARDS
Wear impact-resistant safety goggles – This refers to the operator, as well as for the
persons within the vicinity of the machine. Assess and determine the grade of protection
required depending on the individual case. The risks to others should also be assessed
at this time.
On overhead work, wear a safety helmet. If a work piece, accessories, inserted tools,
or the tool itself breaks, there is danger from high velocity projectiles.
· • Check all parts for damages before using the machine.
• Replace damaged parts immediately.
• When working on brittle material make sure that you are protected against harmful
splinters.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Use only machine tools, accessories and consumables, which are recommended by the
manufacturer. Make sure choosing the correct size and the correct type. Use only accessories,
which are in proper condition and do not touch them during operation.
CAUTION – Injury due to carelessness!
If the machine is fixed to suspension equipment make sure that it is secure. Never
hang the machine onto the supply line.
Separate the machine form any external energy source before changing the
·
machine tool or an accessory.
· Avoid direct contact with the machine tool during and after use as it can be hot or
sharp.
· Wear protective gloves when changing a tool or an accessory!
Notice: Defective/ inappropriate gloves can lead to injury. Only wear proper hand protection,
adapted to the work place requirements.
WARNING – Explosion hazard!
When operating the machine in areas exposed to explosion hazards, use only
accessories, respectively devices, which are ATEX approved and specified.
SAFETY INSTRUCTIONS FOR PREVENTION OF TRANSPORT HAZARDS
ATTENTION – Improper Transport, danger of life due to parts falling down!
Damage of the machine!
· Separate the machine form any external energy source before transportation.
Check that the machine is undamaged and in proper condition.
· Never carry the machine at the supply line.
58