Warranty And Liability - EGAmaster 79760 Manual De Instrucciones

The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Machine does not start
Machine is rotating too
slowly
Gear makes loud
noises
Other problems
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims in
regards to persons or equipment damages are invalid, if one or more of the following causes
apply:
• Improper use of the machine,
• improper assembly, startup, operation or maintenance of the machine,
• operation of the machine with defect safety devices or improperly fixed or non-functioning
safety and protection devices,
• not considering of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine,
• independent structural alterations or settings on the machine beyond the intended purpose,
• inadequate supervision of wear parts,
• improperly carried out repairs, inspections or maintenance,
• catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our
control.
62
TROUBLESHOOTING
Cause
Not connected to hydraulic
supply.
Operating pressure is too low
Cross section of hose too small
Too little flow rate
-
-

WARRANTY AND LIABILITY

Remedy
Connect and open the supply line
Increase the operating pressure
Use a hose with larger cross
section Increase the flow rate
Contact authorized expert
company
Contact authorized expert
company