Kohler K-8549 Manual De Instrucciones página 3

Before You Begin (cont.)
You can extend the distance between the between the water
source and the braided hose connection with 1/2" copper piping
below the rim of the bath/whirlpool, but it may not be safe or
practical. A long run of piping will mean a long run of
room-temperature standing water when the handshower is first
activated for use.
CAUTION: Risk of product damage. Excessive heat will damage
the internal plastic components. Follow these steps to avoid
product damage.
IMPORTANT! Do not apply excessive heat while soldering. Direct
the torch flame away from the brass body.
IMPORTANT! Only apply direct heat to the connectors and
extensions.
Do not install spouts with flow restrictors or handheld shower
units on the large (5/8" O.D.) bath outlet.
The Kohler two-way diverter is designed for use with Kohler
non-diverting bath spouts.
Remove all internal components of the diverter valve before
soldering. Kohler Co. recommends soldering supply and optional
outlet connections to avoid potential leakage.
Kohler Co. reserves the right to make revisions in the design of
products without notice, as specified in the Price Book.
Kohler Co. 3 113290-2-BB