Kohler K-8549 Manual De Instrucciones página 4

Spout 1/2" Nominal
(5/8" OD)
3/4"-14
Hot or
NPSM
Cold 1/2"
Thread
Nominal
(5/8" OD)
Hot or
Cold 1/2"
1/2"-14 NPSM
Nominal
Thread
(5/8" OD)
Handshower 3/8"
Nominal (1/2" OD)
1. Diverter Configuration
The small port is for the supplied handshower hose.
The port directly opposite of the handshower port is for an
optional bath spout. Default flow is through this port. If not
utilized, this port will need to be capped.
The remaining two ports are for the hot and cold water. These
connections are interchangeable.
2. Component Layout
Verify the location of the components, and the orientation of all
ports.
Decide in advance on the location and orientation of the diverter.
The location of the shower, and the handshower, as well as the
direction in which the inlets/outlets point, will affect the piping
and connectors needed.
Allow clearance for valve outlets, handles, and handshower
hoses. For use with an optional spout, also allow clearance for the
spout connection.
You can extend the distance between the between the diverter
and the braided hose connection with 1/2" copper piping below
the rim of the bath/whirlpool, but it may not be safe or practical.
A long run of piping will mean a long run of room-temperature
standing water when the handshower is first activated for use.
113290-2-BB
Layout
4 Kohler Co.