Temporary Interruption Of The Electric Power Supply; Warnings Regarding Routine Maintenance; Elementary Safety Standards; Cleaning External Surfaces - Fulgor Milano fvcd 270 Manual De Uso Y Mantenimento

TEMPORARY INTERRUPTION OF THE ElECTRIC POWER SUPPlY

If a power cut occurs during a functioning cycle, on restore of the power supply, the vacuum chamber
is decompressed and the machine goes back to initial switch-on conditions.
If the power supply is cut-off in Initial switch-on phase, once the power supply is restored the machine
goes back to Initial switch-on.
ATTENTION: In the event of a power outage during the vacuuming process, the vacu-
um state is maintained in the chamber and the lid cannot be opened. Never attempt to
open the lid by force or with the use of tools. Once electrical power is restored it will
again be possible to open the lid.

WARNINGS REGARDING ROUTINE MAINTENANCE

The information and instructions given in this chapter are destined for all staff operating on the ma-
chine: the user and the maintenance technician.

ElEMENTARY SAFETY STANDARDS

To carry out cleaning and routine maintenance operations in safety, follow the regulations given
below:
• Disconnect the machine from the power supply mains without pulling the power supply cable.
• Do not touch the machine with bare, humid or wet hands or feet.
• Do not insert screwdrivers, kitchen instruments or other between the guards and moving parts.
It is prohibited to remove the guards and safety devices in order to carry out routine
maintenance operations. The Manufacturer declines all liability for accidents caused
due to the failure to comply with the above-mentioned obligation.
ATTenTIon! Do not scrape the surfaces with pointed or abrasive objects!
ATTenTIon! For any maintenance, handling, installation and cleaning operations on
the appliance, always use relevant prevention and protection devices (gloves etc.).

ClEANING ExTERNAl SURFACES

BODY FRAME
• The stainless steel external surfaces of FVCD 270 must be cleaned using a soft cloth or sponge
with neutral detergent following the direction of the satin finish.
• It is recommended not to use stainless steel scrubbers, scrapers or abrasive, acid or aggressive
substances, which could damage the surface irreparably.
ATTenTIon! Do not remove the serial number plates during cleaning. These supply
important information regarding the appliance for the technical after-sales service.
60
Instructions for Use
FVCD 270