Sauder Palladia 419117 Manual Del Usuario página 15

Step 11
Fasten seven ANGLE BRACKETS (5G) to the UPRIGHTS (C
å
and D) and SHELF (H). Use seven BLACK 9/16" LARGE HEAD
SCREWS (1S).
Fasten the SHELF MOLDING (X) to the SHELF (H). Use
å
three BLACK 9/16" LARGE HEAD SCREWS (1S) through the
BRACKETS on the SHELF and into the SHELF MOLDING.
Fasten the UPRIGHT MOLDINGS (Y) to the UPRIGHTS (C
å
and D). Use four BLACK 9/16" LARGE HEAD SCREWS (1S)
through the BRACKETS on the UPRIGHTS and into the
UPRIGHT MOLDINGS.
NOTE: There are no pre-drilled holes in the UPRIGHT
å
MOLDINGS. The SCREWS will tighten into the grooves.
Flat edge
Rounded edge
Groove
www.sauder.com/services
Y
X
D
BLACK 9/16" LARGE HEAD SCREW
5G
H
Y
C
419117
1S
(14 used in this step)
5G
(7 used)
5G
Page 15