Important; Black 9/16" Large Head Screw - Sauder Palladia 419117 Manual Del Usuario

Step 12
IMPORTANT: If you purchased the 418739 Electric Fireplace
å
Converter Kit, do not fasten the CENTER BACK (J) to your unit as
shown. You will only fasten the BACKS (I and K).
Carefully turn your unit over onto its front edges. Lay the UPPER
å
BACK (I) over your unit.
Make equal margins along the top and both side edges of the
å
UPPER BACK (I). Push on opposite corners of your unit if needed to
make it "square".
Fasten the top and side edges of the UPPER BACK (I) to the BACK
å
BRACE (L) and ENDS (A and B) using the NAILS (1N).
Fasten the top, bottom, and side edge of each BACK (K) to your unit
å
using the NAILS (1N). The BACKS (K) will overlap the UPPER BACK (I).
Then, fasten the CENTER BACK (J) to your unit. Use twenty-two
å
BLACK 9/16" LARGE HEAD SCREWS (1S). The CENTER BACK (J)
will overlap the BACKS (I and K).
NOTE: Perforations have been provided for access through the
å
BACKS. Carefully cut out the holes needed.
A
The large holes on the
BACKS (K) must be here.
Page 16
L
I
K
J
419117
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
The perforations
should be here.

BLACK 9/16" LARGE HEAD SCREW

(22 used for the CENTER BACK)
K
1N
NAIL
(42 used in this step)
1S
B
www.sauder.com/services