Sauder Palladia 419117 Manual Del Usuario página 9

Step 5
Fasten the HALF DISKS (DD) to the PLINTHS (BB). Use two BROWN 1" FLAT HEAD SCREWS (12S).
å
Fasten the PLINTHS (BB) to the ENDS (A and B). Use four BLACK 9/16" LARGE HEAD SCREWS (1S) through the ANGLE
å
BRACKETS on the ENDS and into the PLINTHS.
Fasten the SIDE MOLDINGS (Z) to the END MOLDINGS (AA). Use eight BLACK 1-1/4" FLAT HEAD SCREWS (7S).
å
NOTE: The SIDE MOLDINGS do not have holes in them. Turn a screw through the END MOLDINGS and into the groove of
å
the SIDE MOLDING. Do not overtighten.
The larger hole should be facing up.
DD
BB
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
BB
DD
The edge of the MOLDING (Z) should
be tight against the HALF DISK (DD).
www.sauder.com/services
DD
BB
1S
B
AA
Z
BROWN 1" FLAT HEAD SCREW
(2 used for the HALF DISKS)
Use the lower
set of holes.
A
419117
12S
DD
BB
Z
AA
7S
BLACK 1-1/4" FLAT HEAD SCREW
(8 used in this step)
Page 9