Bracket - Sauder Palladia 419117 Manual Del Usuario

Step 22
Place the corrugated packing material below the 418739 FIREPLACE
å
to preserve the top surface of the BOTTOM (G). Carefully place
the FIREPLACE in the opening from the back of the unit. Pull the
corrugated packing out from underneath the FIREPLACE.
Fasten two METAL BRACKETS (4G) to the BOTTOM (G) and a
å
BRACKET (60G) to the SHELF (H). Use three BLACK 9/16" LARGE
HEAD SCREWS (1S).
NOTE: The BRACKETS (4G and 60G) do not fasten to the FIREPLACE.
å
NOTE: If you did not purchase the 418739 FIREPLACE at this
å
time but may do so in the future, please keep the hardware
used in this step.
Page 26
7 3 9
G
4 1 8
Caution
Please read all FIREPLACE instructions prior to
installing or removing it from your unit.
Do not plug the FIREPLACE into the power
supply until it is installed and your unit is in its
fi nal position. Do not move the FIREPLACE
while it is plugged into a power supply. Unplug it
before moving it.
When installing or removing the FIREPLACE,
move it in or out from the back, to keep from
scratching the top surface of the bottom.
BLACK 9/16" LARGE HEAD SCREW
4 1 8
419117
1S
(3 used in this step)
H
7 3 9
G
60G
4G
www.sauder.com/services