Black 1-1/8" Machine Screw - Sauder Palladia 419117 Manual Del Usuario

Step 19
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (M) to the HINGE SUPPORT (Q)
å
as shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten a KNOB (33K) to the DOOR (M). Use a BLACK
å
1-1/8" MACHINE SCREW (21S).
Peel the FELT DISC from the FELT DISC CARD (1M) and
å
stick them on the LEFT UPRIGHT (D) where they will
come in contact with the DOOR (M).
Repeat this step for the other DOOR (M).
å
See the next step for DOOR adjustments.
å
33K

BLACK 1-1/8" MACHINE SCREW

(2 used in this step)
www.sauder.com/services
M
1M
21S
Q
D
419117
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
Page 23