Sauder Palladia 419117 Manual Del Usuario página 8

Step 4
Fasten four ANGLE BRACKETS (5G) to the ENDS (A and B).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the edges of the ANGLE BRACKETS are
å
even with the edges of the ENDS.
Fasten the END MOLDINGS (AA) to the ENDS (A and B).
å
Tighten six HIDDEN CAMS.
BLACK 9/16" LARGE HEAD SCREW BLACK 9/16" LARGE HEAD SCREW
(4 used in this step) (4 used in this step)
Surface without
HIDDEN CAMS
AA
5G
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Page 8
1S 1S
B
Start
Arrow
5G
A
Tighten
Maximum
210 degrees
Minimum
190 degrees
419117
Surface with
HIDDEN CAMS
AA
Arrow
www.sauder.com/services