ProMed 5040 SX Instrucciones De Empleo página 24

o
PeratinG tHe unit
• Fill the water tank up to maximum 1-2 cm under the upper edge
of the water glass.
DE
• Regularly clean the water tank from inside by rinsing it with
distilled water.
EN
• Always make sure that no foreign bodies reach in the water
tank. These could block the water tank, water pump, hoses or the
nozzle. Liquids which contain tea tree oil or the similar substances
FR
that can damage the pumps! By using such substances you may
lose any warranty claims!
IT
E. Power and switching
ES • The power cord is permanently installed and is provided with a
flat Europlug (Q). Plug the device with power cord and switch it
on by pressing the button (A)
PT
• Once you switch on the device, the display (F) shows the speed
for the first time (2000 rpm). By switching each time, it switches
PL
to the last selected speed.
• The memory function generally works only when the Start/Stop-
button (B) is pressed before switching the device off.
• The tank is illuminated in blue and the blue LED's on the buttons
(B)
and (G)
• The device is now in standby mode. It may be an individual
appliance operated by the keypad.
.
flash synchronously.
• Place the desired cutter, polisher, etc. in the handpiece chuck.
Doing this never run the hand piece motor. (Please note this „tool
change")
F. Setting the speed
• Take the handpiece from the holder (R), hold it tightly in the hand
(e.g. in the writing position or in the hand grip) and now by
pressing the button (D)
is adjusted as follows:
- From 2000 rpm to 30 000 rpm in 1000th Steps
- From 30 000 rpm to 40 000 rpm in 1000th Steps
• By pressing the button
same level.
• Continuous pressing of the buttons (D)
of the speed levels occur.
• The regulation of the speed is (rpm X 1000) shown in two-digit (F)
on the display. For example, if the speed of the cutter is desired
as 15 000 rpm, press the button (D)
display (F) .
choose the desired speed. The speed
(E) the speed can be reduced at the
or (E) quick run
till it is shown on the