ProMed 5040 SX Instrucciones De Empleo página 25

o
PeratinG tHe unit
G. Rotation activate / deactivate
• Press the Start/Stop button (B)
handpiece.
• The active mode is indicated by long-lasting illuminated blue LED
on the button (B) .
• If you wish to shutdown the motor temporarily, then press the
button again (B) . During the standby mode, the blue LED
blinks on the button (B)
H. Pause-/ Standby Function
• The button (B) provides a „Pause-Standby-function" for overall
operation of the device. It interrupts both handpiece rotation and
also the spray function. The set values are maintained over the
duration of the pause. During the standby state, the blue LED
blinks on the button (B)
• By pressing the button again, the device continue running with
the previous settings.
• The same function can be reached by pressing the micro-
switch at the end of the handpiece (U). Here shows the device by
a double flash button (B)
• When the rotation of the handpiece is deactivated by a
microswitch (U) the blue LED button blinks (B)
interval (2x short; so called „double-pulse flash").
to activate the rotation of the
.
.
is operated by the microswitch (U).
in quicker
• The button (B) has no effect till the rotation is activated again
by the microswitch (U). If you press the button (B)
hear a short beep. In this case the rotation must be activated
again by the microswitch (U) at the end of the handpiece.
I. Retain speed values / memory-function
• With the button (D)
speed can be stored at least for 3 seconds by persistently
pressing any memory-button (J)
For example a low speed for large cutters,
a medium speed for
for high speed and
The following factory made memory values are already specified
here:
- = (8.000 rpm)
- = (15 000 rpm)
- = (24.000 rpm)
These settings can be changed as described.
you will
or (E) the selected motor
, or .
medium-sized cutters and
cutters with small diameter.
DE
EN
FR
IT
ES
PT
PL