Display Function Modes; Parameter Display Mode - Roger Technology B70/2DC Instrucciones Y Advertencias Para El Instalador

7

Display function modes

7.1 Parameter display mode

See chapter 10 for detailed descriptions of the parameters.
7.2 Command and safety device status display mode
BM20 - BR20 - BR21 -BE20 - MONOS4 Serie
COMMAND STATUS
AP PED
PP
CH ORO
POWER
sensing edge, STOP) are normally on. If an indicator is off, the relative device is in alarm state or is not connected.
BH23 Serie
COMMAND STATUS
AP PED
PP
CH ORO
POWER
edge
is in alarm state or is not connected.
N.B.: If the gate open limit switches are enabled (
N.B.: If the gate open limit switches are NOT enabled (
42
VALUE
FT1
COS1
COS2
STOP
FT1
COS1
COS2
STOP
COMMAND STATUS:
FT2 The command status indicators on the display
PED = partial opening
off. They illuminate when a command is received
(e.g.: when a step mode command is received, the
segment PP illuminates).
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments
COMMAND STATUS:
FT2 The command status indicators on the display
PED = partial opening) are normally off. They
FCA2
illuminate when a command is received (e.g.: when
a step mode command is received, the segment PP
illuminates).
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments
are normally on. If an indicator is off, the relative device
=
=
are normally
photocells
photocells, COS1=sensing