Important Safety Instructions For All Battery Chargers - Stanley PB2500 Smart Manual De Instrucciones

•
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving
parts. Loose clothes, jewelry or long hair can be caught in moving parts.
•
Adopt a firm footing or a stable position before operating the tool.
•
Operators and others in work area must wear ANSI Z87.1 CAN/CSA Z94.3 or other approved safety glasses with
side shields. Always wear safety glasses and ear protection during operation.
•
Adequate clearance is required for the tool operator's hands before proceeding.
•
Do not operate a tool that is directed towards any person(s).
•
DO NOT operate tool with the nose housing removed.
•
Do not operate the tool or the charger in an explosive atmosphere or environment allowing exposure to
combustible fluids or gasses.
•
Do not operate the tool or the charger in an environment allowing exposure to moisture or rain to avoid risk of
electric shock.
•
Do not abuse the tool by dropping or using it as a hammer.
•
Keep dirt and foreign matter out of the air vents of the tool as this will cause the tool to malfunction.
•
Keep tool handles dry, clean, and free from oil and grease.
•
When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent activation.
•
Never leave installation tool unattended.
•
Disconnect battery when tool is not in use.
1.3

IMPORTANT SAFETY INSTRUCTIONS FOR ALL BATTERY CHARGERS

SAVE THESE INSTRUCTIONS: This manual contains important safety and operating instructions for compatible
battery chargers (refer to Technical Data).
•
Before using charger, read all instructions and cautionary markings on charger, battery pack, and product
using battery pack.
WARNING: Shock hazard. Do not allow any liquid to get inside charger. Electric shock may result.
WARNING: We recommend the use of a residual current device with a residual current rating of 30mA or
less.
CAUTION: Burn hazard. To reduce the risk of injury, charge only DEWALT® rechargeable batteries. Other
types of batteries may burst causing personal injury and damage.
CAUTION: Children should be supervised to ensure that they do not play with the appliance.
NOTICE: Under certain conditions, with the charger plugged into the power supply, the exposed charging contacts
inside the charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not
limited to, steel wool, aluminium foil or any build-up of metallic particles should be kept away from charger cavities.
Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before
attempting to clean
•
DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger
and battery pack are specifically designed to work together.
•
These chargers are not intended for any uses other than charging DEWALT® rechargeable batteries. Any other
uses may result in risk of fire, electric shock or electrocution.
•
Do not expose charger to rain or snow.
•
Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and
cord.
•
Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage
or stress.
E N G L I S H
7