Description; Function; Commission - Festo Robotino 4 Instrucciones De Utilizacion

Interface Box

7 Description

7.1 Function

The Interface Box can be integrated into the Robotino. With the Interface Box you can extend electrical
signals without high wiring costs. Plug the connector cables of the electrical component into the sockets
supplied. Then plug the sockets into the socket strips of the Interface Box. From the Interface Box a 50 pin
connector cable leads to the connector strips of the control unit and chassis of the Robotino.
The interfaces on the Robotino are mirrored on the Interface Box. The designations on the Interface Box are
identified by the ' sign. The Interface Box generates a 5 V voltage from the 24 V operating voltage, which can
be used to supply sensors.

7.2 Commission

You have two possibilities to mount the Interface Box:
Mounting on the height adjuster
1. Position the Interface Box on the height
adjustment.
2. Place the four supplied M3 cylinder head screws
with matching washers on the through holes of
the Interface Box.
3. Tighten the screws.
4. Plug the bushings of the 50-pin connector cable
into the control unit and the chassis of the
Robotino. The correct slot can be found in the
socket designations.
32
Mounting on an H-rail
1. Position the DIN rail mounting on the Interface
Box
2. Place the three supplied M3 panhead screws
with matching washers on the holes of the DIN
rail mounting.
3. Tighten the screws.
4. Now plug the Interface Box onto the DIN rail.
5. Plug the bushings of the 50-pin connector cable
into the control unit and the chassis of the
Robotino. The correct slot can be found in the
socket designations.
© Festo Didactic 8125219