Carrier 40VL0058-7E-QEE Manual De Instalación Y Propietario página 19

Installation Procedures
Diagram of pipe
[Rear piping]
• Draw the pipes and the drain hose, then fasten them using an adhesive tape.
[Left-Left-rear piping]
• In case of left side piping, cut away the excess using a snipper
1. In case of left-rear piping, bend the pipes according to the piping instructions Coat the flaring seal face with refrigerant
oil and connect the pipes.
Cover the connected part using heat insulation materials and ensure that you are fixing it using adhesive tapes.
Heat insulation material
[Other direction piping]
Fixing the indoor unit body
Indoor installation can be done in one of the following two ways:
Hanging wall
Wall board
Indoor/outdoor electric cable
Drain hose
Lid for right
piping
Fix with adhesive
tape
Piping
Pipe supporting
plate
Console mode
12
Lid for left
piping