Kit Assembly - Metra 99-7369B Instrucciones De Instalación

1. From the factory radio trim panel, remove (2)
screws from each vent, attach them into the radio
trim panel, and then secure using the same screws.
2. From the factory radio trim panel, remove (4)
panel clips, and then attach them onto the radio
trim panel.
3. Attach the pocket to the radio brackets using the
(2) supplied #8 x 3/8" Phillips screws. (Figure A)
4. Remove the metal DIN sleeve and trim ring from
the aftermarket radio.
5. Slide the radio into the bracket/pocket assembly
and then secure with the screws supplied with
the radio. (Figure B)
6. Locate the factory wiring harness and
connector in the dash and complete all necessary
connections to the radio. Metra recommends using
the proper mating adapter from Metra and/or
AXXESS. Test the radio for proper operation .
7. Secure the completed assembly into the dash
using the factory screws.
8. Snap the radio trim panel over the completed
assembly and then reassemble the dash in
reverse order of disassembly.
(
Figure A)
antenna

KIT ASSEMBLY

(Figure B)
REV. 11/13/2017 INST99-7369B
3