ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Secure the radio brackets to the
radio using the screws supplied
with the radio. (Figure A)
3. Secure the pocket to the radio
bracket assembly using (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
4. Secure the climate control to the
completed assembly using the
factory hardware. (Figure A)
5. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and
factory components. Metra
recommends using the proper
mating adapter from Metra and/or
Axxess. Test the radio and climate
controls for proper operation.
6. Attach the (2) panel clips supplied
onto the radio trim panel, snap
the panel to the vehicle, and then
reassemble the dash in reverse
order of disassembly. (Figure B)
Kit Assembly
(Figure A)
(Figure B)
®
99-8233B
ISO DDIN radio provision
1. Secure the radio brackets to the
radio using the screws supplied
with the radio. (Figure A)
2. Secure the climate control to the
completed assembly using the
factory hardware. (Figure A)
3. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and
factory components. Metra
recommends using the proper
mating adapter from Metra and/or
Axxess. Test the radio and climate
controls for proper operation.
4. Attach the (2) panel clips supplied
onto the radio trim panel, snap
the panel to the vehicle, and then
reassemble the dash in reverse
order of disassembly. (Figure B)
3
(Figure A)
(Figure B)