Kit Assembly - Metra 99-7359B Instrucciones De Instalación

1. Secure the radio brackets to the pocket
using the (4) #8 x 3/8" Phillips screws
provided. (Figure A)
2. Secure the bracket/pocket assembly to
the radio trim panel using the (4) #8 x
3/8" Phillips screws provided. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/housing/
pocket assembly, then secure it using
the screws supplied with the radio.
(Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Secure the radio assembly to the dash
using the factory screws.
7. Reassemble the dash in reverse order of
disassembly to complete the installation.

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
REV. 5/14/2018 INST99-7359B
3