Patient Preparation - I-Tech MIO-PERISTIM Manual De Instrucciones

• any addition, modification and/or repair are carried out by
authorized personnel;
• the environmental electrical installation to which MIO-PERISTIM is
connected is compliant to the national laws;
the instructions for use contained in this manual are strictly
•
followed.
Should any foreign materials penetrate the device contact the retailer or
manufacturer immediately. If dropped down, check that the housing is not
cracked or damaged in any way; if so, contact the retailer or manufacturer.
Should you notice any changes in the device's performance during treatment,
interrupt the treatment immediately and consult the retailer or
manufacturer.
If the stimulation is uncomfortable decrease intensity. If the problem
persists consult a doctor.
Some patients could suffer from skin irritation or oversensitivity due
to stimulation or gel. If the problem persists, suspend the stimulation
and consult a doctor.
Consult a doctor before using MIO-PERISTIM with metallic
osteosynthesis devices.
IF YOU HAVE ANY DOUBTS REGARDING THE DEVICE USE CONSULT YOUR
DOCTOR.

Patient preparation

Before using MIO-PERISTIM clean the skin of the area to be treated; with the
cable disconnected from MIO-PERISTIM, connect the electrostimulation cable
jacks to the self-adhesive electrodes; position the self-adhesive electrodes on
the skin (see photos of electrode positions in the Positions manual); connect
the impulse transmission cables to the relative jacks (Channel 1 and/or
Channel 2), then turn MIO-PERISTIM on.
Splitting leads use: please use splitting leads if you want to double electrodes
number for each channel. Connect the splitting cable jacks to the self-
adhesive electrodes, with the cable disconnected from MIO-PERISTIM;
position the self-adhesive electrodes on the skin (see photos of electrode
positions in the Positions manual); connect the splitting leads cables to the
impulse transmission cables that are connected to the relative jacks (Channel
1 and/or Channel 2), then turn MIO-PERISTIM on.
Make sure that MIO-PERISTIM is switched off before disconnecting
the electrodes at the end of the treatment.
IACER Srl 52 MNPG152-07