Device Use; Operating Instructions - I-Tech MIO-PERISTIM Manual De Instrucciones

Device use

MIO-PERISTIM has 14 preadjusted TENS programs, 9 preadjusted URO
programs and 12 free memories adjustable by the user to create programs
according to his needs. The program MEM 13 is a battery test.

Operating instructions

It is recommended reading the entire user manual before using.
To start the therapy, turn MIO-PERISTIM on using the
PREADJUSTED PROGRAMS
Read the follow instructions to use the preadjusted programs and start the
therapy:
1. Select the program group using the MODE/ESC button (TENS, URO,
MEM).
2. Select the program using PRG+ and PRG- buttons (make reference to
the follow sections to get all technical specifications).
3. Increase current intensity for the channels using CH1 and CH2 (▲)
buttons. The value can be adjusted with stepping 1mA. Press CH1
and CH2 (▼) buttons to decrease the intensity.MIO-PERISTIM
recognize the electrodes connection: in case of faulty connection,
when the intensity reaches 15mA the value is resetted to zero.
4. The remaining time is showed on the display of MIO-PERISTIM. An
acoustic signal advises the user when the treatment is completed.
5. Turn off the device keeping pressed the
two seconds.
FREE MEMORIES (ADJUSTABLE PROGRAMS)
With MIO-PERISTIM you can set the parameters according to your needs or
indicated by the doctor/physical therapist using the MEM programs.
Read the following instructions to adjust the parameters:
1. Select MEM by pressing MODE/ESC button. Scroll the programs
using PRG+ and PRG- buttons to display the preadjusted technical
specifications. Read the following instructions to adjust the chosen
program parameters: time, frequency and width impulse.
2. Adjust
▼(decrease) CH1 or CH2 buttons by increasing and decreasing the
time value. Press SET to confirm.
IACER Srl
therapy time TIME-min, pressing
53
button.
button for at least
▲(increase) and
MNPG152-07