Generac G0061030 Guia De Instalacion página 12

Unpacking and Inspection
Figure 2-3. Circuit Breaker Box and Keys
5. Cut the cable tie to remove the keys.
6. Use the keys to open the lid of the generator.
A
B
8
000932
A
Figure 2-4. Side Lock Location and Front Panel Removal
NOTE: The enclosed keys provided with this unit are
intended for service personnel use only.
7. There are two locks securing the lid, one on each
side (A in Figure
press down, on the lid, above the side lock and
unlock the latch.
8. Repeat for the other side. If pressure is not applied
from the top, the lid may appear stuck.
NOTE: Always verify that the side locks are unlocked
before attempting to lift the lid.
9. Once the lid is open, remove the front access
panel by lifting it up and out.
NOTE: Always the lift the front access panel up before
pulling away from enclosure (B and C in
not pull the panel away from the enclosure before lifting
up (D in Figure 2-4)
C
Installation Guidelines for 60 Hz EcoGen™ Generator
2-4). To properly open the lid,
Figure
D
2-4). Do