Menu Navigation; Change Time And Date; Programmable Timers; Dealer Programmable - Generac G0061030 Guia De Instalacion

Control Panel/Start–Up/Testing

Menu Navigation

Feature
System Menus
HOME Screen The system returns to the Home screen if the control pad is not used for five minutes. The screen normally
displays a Status message, such as Ready to Run (Auto mode) or Switched to OFF (Off mode), and the
total Hours of Protection. If an active alarm/warning condition occurs, the associated Alarm/Warning
message is displayed. To clear the Alarm/Warning message, press OFF on the control pad followed by
ENTER. In the event of multiple Alarms/Warnings, the next message is then displayed. The highest priority
alarm is always displayed first.
MAIN MENU Enables the operator to navigate the software using UP ARROW, DOWN ARROW, ENTER and ESCAPE.
The Main Menu can be accessed from any sub menu by consecutively pressing ESCAPE. Each time
ESCAPE is pressed, the preceding menu is displayed. The Main Menu is reached when the System,
Date/Time, Battery, and Sub Menus are displayed.
Navigation
ESCAPE Used to abort a routine or back up to the preceding menu.
ENTER Used to make a selection or save an entry.
UP ARROW Used to move forward or backward from menu to menu or to scroll forward or backward (increment or
DOWN ARROW decrement) through available selections.
NOTE: Pressing any button on the control pad illuminates the backlight for 30 seconds. The backlight also illuminates for 30
seconds whenever an active Alarm/Warning message is displayed.

Change Time and Date

To change the time and date, see the Navigation Menu in
Figure 7-5. If power is lost (battery is disconnected/
reconnected, 7.5 amp fuse is removed/installed, etc.), the
display automatically prompts the user for the Time and
Date. All other information is retained in memory.

Programmable Timers

Dealer Programmable

NOTE: A dealer password is required.

High Run Speed Timer

A programmable high run speed timer is provided. The
timer controls the length of time the generator runs at
maximum speed after application of a large load (such as
an air conditioner). The time can be increased to prevent
the potential cycling of engine RPM as loads turn on and
off. For example, if the timer is currently set to ten
minutes, and the normal AC cycling time is 15 minutes,
increasing the timer to 20 minutes would prevent the
engine speed from increasing and decreasing every ten
minutes between AC
consumption would increase).
30
cycles (even though
Description

USB Port for Firmware Updates

A USB port is located beneath the rubber flap adjacent to
the control pad, and is provided for firmware updates.
Firmware updates must be performed by an Independent
Authorized Service Dealer.
NOTE: The USB port is intended for use with a USB
thumb drive only. The USB port is not intended for
charging devices such as phones or laptops. Do not
connect any consumer electronics to the USB port.

Activation

To receive the activation code, you must have the unit serial
number and go to:
Support" Tab and then "Activate Your Home Standby" under
the "Generac Owners" list. You can also receive an
activation code by calling 1–888–9ACTIVATE (1–888–922–
8482).
Activating the generator is a simple, one–time process
that is guided by the controller screen prompts. Once the
product is activated, the controller screen will not prompt
you to activate again, even if you disconnect the
generator battery, fuse and battery charge circuit (T1 60
fuel
Hz / T1 & T2 50 Hz).
After obtaining your activation code, please complete the
following steps at the generator's control panel:
1. Upon first power up of the generator, the display
interface will begin an installation wizard.
Installation Guidelines for 60 Hz EcoGen™ Generator
www.generac.com, "Service &