The Input Setting Menu - Sony VPL-CS10 Manual De Instrucciones

The INPUT SETTING
Menu
The INPUT SETTING menu is used to
adjust the input signal.
Items that cannot be adjusted depending on
the input signal are not displayed in the
menu.
For details on the unadjustable items, see
page 42.
When the video signal is input
INPUT SETTING
ASPECT: 4 : 3
When the RGB signal is input
INPUT SETTING
DOT PHASE:
1 5
SIZE H 8 0 0
H : 2 0 0
SHIFT H
SCAN CONV: ON
MENU Items
DOT PHASE
Adjusts the dot phase of the LCD panel and
the signal input from the INPUT A
connector.
Adjust the picture further for finer picture
after the picture is adjusted by pressing the
APA key.
Adjust the picture to where it looks clearest.
28
GB

The INPUT SETTING Menu

VIDEO
Memory
N o . 0 1
No.
VIDEO/60
Signal
type
INPUT-A
V : 3 0
Memory
N o . 1 3
No.
640 480
Signal
type
SIZE
Adjusts the horizontal size of picture input
from the INPUT A connector. The higher
the setting, the larger the horizontal size of
the picture. The lower the setting, the
smaller the horizontal size of the picture.
Adjust the setting according to the dots of
the input signal.
For details on the suitable value for the
preset signals, see page 43.
SHIFT
Adjusts the position of the picture input from
the INPUT A connector. H adjusts the
horizontal position of the picture.V adjusts
the vertical position of the picture. As the
setting for H increases, the picture moves to
the right, and as the setting decreases, the
picture moves to the left.
As the setting for V increases, the picture
moves up, and as the setting decreases, the
picture moves down. Use the < or the ,
key to adjust the horizontal position and the
M and m key for the vertical position.
SCAN CONV (Scan converter)
Converts the signal to display the picture
according to the screen size.
ON: Displays the picture according to the
screen size. The picture will lose some
clarity.
OFF: Displays the picture while matching
one pixel of input picture element to that
of the LCD. The picture will be clear but
the picture size will be smaller.
Note
This item will not be displayed in the following
case.
VPL-CS10: When SVGA, XGA or SXGA
signal is input.
VPL-CX10: When XGA or SXGA signal is
input.