Maintenance; Replacing The Lamp - Sony VPL-CS10 Manual De Instrucciones

Maintenance

B
Maintenance

Replacing the Lamp

When it is time to replace the lamp, replace
the lamp promptly with a new LMP-C132
Projector Lamp.
When replacing the lamp after using
the projector
Turn off the projector, then unplug the
power cord.
Wait for at least an hour for the lamp to cool.
Caution
The lamp becomes a high temperature after
turning off the projector with the I / 1 key. If
you touch the lamp, you may scald your finger.
When you replace the lamp, wait for at least an
hour for the lamp to cool.
1
Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can see its
underside.
Note
Be sure that the projector is stable after
turning it over.
2
Open the lamp cover by loosening a
screw with the Phillips screwdriver
(supplied with the LMP-C132
Projector Lamp).
Note
For safety sake, do not loosen any other
screws.
3
Loosen the screw on the lamp unit
with the Phillips screwdriver. Pull out
the lamp unit by the handle.
3
2
4
Insert the new lamp all the way in until
it is securely in place. Tighten the
screw. Fold up the handle.
3
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
5
Close the lamp cover and tighten the
screws.
Handle
1
2
1
31
GB
Maintenance