Troubleshooting; Fault Correction - Grizzly Tools BRM 56-163 BSA Q-360 Traducción Del Manual De Instrucciones Original

GB

Troubleshooting

Problem
Engine does not
start
Engine starts but
equipment does
not run at full
power
Engine splutters,
stops
Engine overheats
Drive does not
switch on
Output unsatis-
factory or engine
labouring
Blade does not
turn
Abnormal noises,
rattling or vibra-
tions
110
Possible Cause
Battery ( 25) is empty or
not inserted
Defective start lever (
Too little petrol in the tank
Incorrect starting sequence
Spark plug connector
not put on correctly
Sooted spark plug (
Incorrectly adjusted carburet-
tor mix
Dirty air filter (
Incorrectly adjusted carburet-
tor mix
Incorrectly adjusted carburet-
tor mix
Sooted spark plug (
Ventilation holes blocked
Incorrect spark plug (
Too little engine oil in the en-
gine
Bowden cables (
adjusted
Grass too short or too long
Blade blunt
Blade blocked with grass,
grass collection box full
( 19), ejection channel
blocked
Blade blocked with grass
Blade not installed correctly
Blade not installed correctly
Blade damaged

Fault Correction

Check charge level,have repairs
carried out by a qualified electri-
cian, if necessary
Repair by customer services
22)
Fill with petrol
Follow the instructions for starting
the engine (see "operation")
Attach the spark plug connector
( 11)
Clean, adjust or replace the spark
plug (see "cleaning and mainte-
34)
nance")
Have the carburettor adjusted by a
specialist workshop
Replace the air filter (see "cleaning
13)
and maintenance")
Have the carburettor adjusted by a
specialist workshop
Have the carburettor adjusted by a
specialist workshop
Clean, adjust or replace the spark
34) plugs (see "cleaning and mainte-
nance")
Clean the ventilation slot
Change the spark plug
34)
Fill with engine oil (see "initial op-
eration")
Adjust the Bowden cables or have
36) mis-
P
them adjusted by a specialist work-
shop
Change the cutting height (see
"setting the cutting height")
Have the blade sharpened or re-
placed by a specialist workshop
Remove the grass (see "cleaning
and maintenance")
Remove the grass
Have the blade installed by a spe-
cialist workshop
Have the blade installed by a spe-
cialist workshop