Removal And Replacement; Removal; Waste Disposal - Aventics RAK Instrucciones De Servicio

AVENTICS
8

Removal and replacement

8.1

Removal

The only time removal will be necessary is when replacing or
scrapping the device.
Switch off all compressed air from the relevant part of the
1.
system.
Remove any devices that do not belong to the Drehantrieb
2.
itself.
Remove all attachments and move the Drehantrieb away from
3.
the part of the system.
Pack the Drehantrieb for transport or recycling.
4.
Install the replacement unit as described in "Installation" on
5.
page 39.
8.2

Waste disposal

Scrap the device in accordance with local regulations. Among
other things, the Drehantrieb contains lubricating grease that
may pollute the environment.
| RAK | R402005099–BDL–001–AB 51