Fault Remedy - Brill Evolution 41 EM Manual Del Usuario

GB

Fault remedy

Danger - risk of injury!
Before all maintenance and care, always pull the mains plug, and wait until the cutting blade comes to a standstill!
Fault
Motor does not run
Reduced motor
performance
Grass catcher does not
fill up completely
Unusual noises
Irregular running, strong
vibration of the unit
Lawn becomes yellow
Cut uneven
Tracks of mower too
deep during mowing
If faults are not listed in this table or you are unable rectify them yourself, please consult our customer service
department.
18
Possible cause
No power supply
Unit cable defective
Cutting blade blocked
Too much grass in
the discharge chute
or housing
Cutting blade blunt
Lawn is wet
Grass catcher clogged
Too much grass in
the discharge chute
or housing
Cutting blade blunt
Screws loose
Cutting blades damaged
Cutting blade blunt
Cutting height too low
Soil softened by
moisture, lawn too wet
Solution
Check the in-house fuse / extension cable
Contact the AL-KO service centre / an authorised
specialist firm
Clean discharge chute / housing, the cutter blade must
turn freely
Current the cutting height for lower grass or previously
mowed areas
Clean discharge chute / housing
Correct the cutting height
Contact an AL-KO service centre or authorised specialist
firm and have the cutting blades sharpened or replaced
Allow the lawn to dry
Clean the grass catcher grid
Clean discharge chute / housing
Correct the cutting height
Contact an AL-KO service centre or authorised specialist
firm and have the cutting blades sharpened or replaced
Tighten screws
Consult AL-KO service centre
Have cutting blade exchanged
Have the cutting blades exchanged or sharpened
Raise cutting height
Let the lawn dry, do not mow when the grass is wet
Translation of original user instructions