Hardware Contents; Preparation; Safety Information - Harbor Breeze LARALYN LRN32 Manual Del Usuario

HARDWARE CONTENTS

BB
AA
Wire Connector
Qty. 4
Fan Pull Chain
Extension
Qty. 1
EE
Blade Screw
Qty. 16

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts
with package contents list and hardware contents list. If any part is missing or damaged,
do not attempt to assemble the product.
Estimated Assembly Time: 45 minutes.
Tools Required for Assembly (not included): Phillips screwdriver, step ladder, electrical
tape, pliers, wire cutters, wire strippers.
Helpful Tools (not included): Electrical circuit tester.
CC
DD
Plastic Plug
Qty. 1
Light Pull Chain
Extension
Qty. 1
EE
FF
Blade Bracket
Rubber Gasket
Screw with
Qty. 1
Washer
(not to scale)
Qty. 8
4

SAFETY INFORMATION

READ AND SAVE THESE INSTRUCTIONS
Please read and understand this entire manual before attempting to assemble, operate or install the product.
• When using an existing outlet box, be sure the box is securely attached to the building structure and can
support the full weight of the fan, so to avoid potential serious injury or death.
• All wiring must be in accordance with the National Electrical Code "ANSI/NFPA 70-1999" and local electrical
codes. Electrical installation should be performed by a qualified licensed electrician.
• DO NOT use bulbs with wattage greater than the maximum value stated on the fixture and in this manual.
Using a higher wattage bulb than specified will increase fixture temperature and cause risk of fire.
• Disconnect the electrical supply circuit to the fan before installing kit.
• Electrical diagrams are for reference only.
• Using a full range dimmer switch to control fan speed will cause aloud humming noise from fan.
• To reduce the risk of fire or electric shock, do NOT use a full range dimmer switch to control.
• The net weight of this fan including the light kit is: 13.67 lbs.
WARNING
• ELECTRIC SHOCK HAZARD - To reduce the risk of electric shock, do not use this fan with any solid-state
speed control device.
• ELECTRIC SHOCK HAZARD - To reduce the risk of electric shock, make sure the electricity has been turned
off at the circuit breaker or fuse box before beginning installation.
• PERSONAL INJURY HAZARD - To reduce the risk of injury to persons, install fan so the blades are 7 ft.
above the floor.
• FIRE, ELECTRIC SHOCK OR PERSONAL INJURY HAZARD - To reduce the risk of fire, electric shock,
or personal injury, mount to an outlet box marked "ACCEPTABLE FOR FAN SUPPORT OF 35 lbs OR
LESS" and use the mounting screws provided with the outlet box. Most outlet boxes commonly used for
the support of lighting fixtures are not acceptable for fan support and may need to be replaced. Consult a
qualified licensed electrician if in doubt.
CAUTION
• PERSONAL INJURY HAZARD - To reduce the risk of personal injury, do not bend the blade brackets when
installing the brackets, balancing the blades, or cleaning the fan. DO NOT insert foreign objects in between
the rotating fan blades.
5