Closemount Style Fan Mounting - Harbor Breeze LARALYN LRN32 Manual Del Usuario

DOWNROD STYLE FAN MOUNTING
3. Loosen preassembled set screws from the
yoke on motor housing assembly (H). Slip
downrod (E) into yoke, aligning holes on both
parts. Insert previously removed pin through
holes on yoke and downrod (E), then insert
previously removed clip into the pin until it
snaps into place.
4. Tighten set screws. Slide the yoke cover (D)
down over the motor housing assembly (H).
5. Install hanger ball on the top of downrod (E)
into mounting bracket (A) opening. Rotate fan
until slot on hanger ball engages the tab on
the mounting bracket (A).
WARNING: Be careful when aligning the tab
to the slot! If not fully engaged, there is a
possibility of fan falling, which may result in
serious injury or death.
Proceed to the WIRING section on page 10.
3
Clip
Pin
Set
screw
4
Set screw
5
E
Slot Tab
B
8

CLOSEMOUNT STYLE FAN MOUNTING

1. Remove the canopy cover (C) from the
bottom of the canopy (B).
E
H
2. Remove three of the six screws and lock
washers (every other one) securing the
motor collar to the top of the motor housing
assembly (H).
D
3. Place rubber gasket (GG) over remaining
screws. Pull wires through hole in canopy
(B) and attach canopy (B) to motor
housing assembly (H).
A
Hardware Used
GG Rubber gasket
1
C
2
H
3
B
GG
x 1 H
9
B