Stopping The Engine; Adjusting Engine Idle; Important; Checking Unit Condition - Shindaiwa LE242/EVC Manual Por Propietario/Operador

Starting the Engine (continued)
Starting A Flooded Engine
1. Disconnect the spark plug lead and use
the spark plug wrench to remove the
spark plug (turn counter clockwise to
remove).
2. Slide the ignition switch to the "O"
(STOP) position.
■
If the spark plug is fouled or
soaked with fuel, clean the plug as
necessary.

Stopping the Engine

1. Idle the engine briefly before stopping
(about 2 minutes).
2. Slide the ignition switch to the "O"
(Engine OFF) position.

Adjusting Engine Idle

The engine must return to idle speed
whenever the throttle lever is released.
Idle speed is adjustable, and must be set
low enough to permit the engine clutch to
disengage the cutting attachment.
WARNING!
The cutting attachment must
NEVER rotate at engine idle! If the
idle speed cannot be adjusted by the
procedure described here, return the
trimmer to your Shindaiwa dealer for
inspection.

Checking Unit Condition

NEVER operate the unit with the cut-
ting attachment shield or other protec-
tive devices removed!
Use only authorized Shindaiwa parts and
accessories with your Shindaiwa trimmer.
Do not make modifications to this unit with-
out written approval from Shindaiwa, Inc.
ALWAYS make sure the cutting attach-
ment is properly installed and firmly
tightened before operation.
NEVER use a cracked or warped
cutting attachment: replace it with a
ser viceable one.
All manuals and user guides at all-guides.com
3. Open the choke and fully depress the
throttle lever with your left hand, then
pull the starter handle rapidly with your
right hand to clear excess fuel from the
combustion chamber.
4. Replace the spark plug and tighten it
firmly with the spark plug wrench. If a
torque wrench is available, torque the
spark plug to the values recommended
in the "Specifications" section.
Idle Speed Adjustment
1. Place the unit on the ground, then start
the engine, and then allow it to idle 2-3
minutes until warm.
2. If the attachment rotates when the
engine is at idle, reduce the idle speed
by turning the idle adjustment screw
counter-clockwise.
3. If a tachometer is available, adjust idle.
Check Specifications page for correct
idle speed
NOTE
Carburetor fuel mixture adjustments are
preset at factory and cannot be serviced
in the field.
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could dam-
age the engine.
5. Repeat the starting procedure for a
warm engine.
6. If the engine still fails to start, refer to
the troubleshooting section near the
end of this manual.
OFF OFF
When the unit is turned off make sure the
cutting attachment has stopped before the
unit is set down.
Idle
adjustment
screw
Adjusting
engine idle
NEVER operate a unit with worn or dam-
aged fasteners or attachment holders.
WARNING!
A cutting attachment shield or
other protective device is no guarantee
of protection against ricochet. YOU
MUST ALWAYS GUARD AGAINST
FLYING DEBRIS!

IMPORTANT

9