Publicidad
Step 10
Fasten the PLINTHS (S and T) to the FRONT BRACE (P). Use eight SILVER 1-1/8" FLAT HEAD SCREWS (GG).
å
NOTE: There are no pre-drilled holes in the PLINTHS. The SCREWS will tighten into the grooves. The OUTER PLINTHS
å
have only one notch and the INNER PLINTHS have two notches. Pay close attention to the positioning of the PLINTHS.
Fasten the LARGE METAL BRACKET (X) to the BOTTOM (F). Use a BLACK 9/16" LARGE HEAD SCREW (II).
å
Now, insert the SKIRTS (L and M) into the notches of the PLINTHS.
å
NOTE: Be sure the LONG SKIRT is positioned in front of the LARGE METAL BRACKET.
å
The notch should
be located here.
Page 14
GG
SILVER 1-1/8" FLAT HEAD SCREW
(8 used in this step)
M
F i n i
F
T
d
s h e
P
S
(1 used for the LARGE METAL BRACKETS
X
412871
L
d
i s h e
F i n
S
BLACK 9/16" LARGE HEAD SCREW
www.sauder.com/services
M
d
s h e
F i n i
T
The notch should
be located here.
II
Publicidad
