Sauder 412871 Instrucciones De Montaje página 16

Step 12
Carefully stand your unit upright.
å
Fasten two HINGES (Z) and HINGE SPACERS (22H) to a DOOR (I2).
å
Use four SILVER 5/8" FLAT HEAD SCREWS (23S).
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten a DOOR (I2) to the RIGHT END (A). Use the screws in the
å
HINGES. See the next step for door adjustments.
Peel a FELT DISC from the FELT DISC CARD (BB) and stick it on
å
the DOOR where it comes in contact with the RIGHT UPRIGHT (C).
Fasten a KNOB (AA) to the DOOR (I2). Use a GOLD 1" MACHINE
å
SCREW (HH).
Repeat this step for the other DOOR (I2).
å
Page 16
A
C
I2
Z
412871
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
BB
I2
BB
22H
GOLD 1" MACHINE SCREW
(2 used for the KNOBS)
SILVER 5/8" FLAT HEAD SCREW
(8 used for the HINGES)
AA
HH
23S
www.sauder.com/services