Sime Brava Slim HE 25 T Manual De Instalación Y Mantenimiento página 65

EN
pressing any one of these buttons for more than 30 seconds
NB:
generates a fault on the display without preventing boiler
operation.The warning disappears when normal conditions are
restored.
DISPLAY
1
l
. This symbol appears when the boiler is
"SUMMER"
operating in "Summer" mode or if only the domestic
hot water mode is enabled via the remote control. If the
symbols l and n are flashing, this indicates that the
chimney sweep function is active.
n
. This symbol appears when the boiler is
"WINTER"
operating in "Winter" mode or if both the domestic hot
water and heating modes are enabled via the remote
control. With the remote control, if no operating modes
have been enabled both symbols
d
. The message indicates that after
"RESET REQUIRED"
having repaired the fault, normal boiler operation can be
restored by pressing the button
r
. This symbol is present during
"DOMESTIC HOT WATER"
a DHW request or during the "chimney sweep function"
It flashes during the selection of the domestic hot water
set point.
t
. This symbol lights up during heating
"HEATING"
operation or during the "chimney sweep function It
flashes during the selection of the heating set point.
f
"BLOCK" DUE TO NO FLAME
F
"FLAME PRESENCE" .
v
"POWER LEVEL" . This indicates the power level at which
the boiler is operating.
p
"PARAMETER" . This indicates that the user may be in
parameter setting/display, or "info" or "counter", or in
"activated alarms" (history).
A
. This indicates that a fault has occurred. The
"ALARM"
number specifies the cause which generated the alarm.
z
"CHIMNEY SWEEP" . This indicates that the "chimney
sweep function" has been activated.
e
"EXTERNAL SENSOR" . This indicates that the external
sensor has been installed and that the boiler is working
on a sliding temperature.
a
"HEATING SYSTEM PRESSURE"
pressure.
All manuals and user guides at all-guides.com
l and n will be off.
y .
.
. Display of heating system
65