Maintenance Checklist - Stanley BOSTITCH N62FNB Especificaciones Técnicas

Maintenance Checklist

Maintenance
Inspect trigger performance
Drain condensation from air
compressor tanks and air filters (if
present)
Clean magazine assembly
Clean nose assembly
Ensure all fasteners remain tight
Check/clean air inlet air filter
Replace no-mar tip
Replace swivel air fitting
Replace piston/driver assembly
Replace O-rings
Replace bumper
Replace headvalve
Replace engine cylinder
Technical Data:
Please look for the technical data in the table at the front of this manual.
A Length mm.
B Height mm.
C Width mm.
D Weight Kg.
E Noise L , 1s, d
PA
F Noise L , 1s, d
WA
G Noise L , 1s, 1m
PA
H(a) Vibration m/s
H(b) Vibration Uncertainty (m/s
I P max Bar
J P min Bar
Benefit
Ensure trigger system is in
proper working order
Prevents accumlation of
moisture that can impede tool
performace
Prevents accumlation of debris
that could cause a jam
Prevents accumlation of debris
that could cause a jam
Prevent loose parts
Maintains proper air flow to
engine for peak performance.
Prevents marks in softwood
applications
Maintains proper air flow to
engine for peak performance
Maintains consistent drive
quality
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
2
2 )
Procedure
Refer to Tool Operation Check section in this
manual
Open drain cock on tanks and air filters and
drain all condensate
Blow clean with compressed air
Blow clean with compressed air
Tighten all fasteners with appropriately sized
hex wrench
Remove end cap and use compressed air
blow gun to blow filter clean. Replace filter
as required.
Remove worn no-mar tip and replace with a
new tip (a spare tip is located on the
magazine)
Remove worn swivel air fitting and replace
with new swivel fitting
Refer to replacement part kit instructions
Refer to replacement part kit instructions
Refer to replacement part kit instructions
Refer to replacement part kit instructions
Refer to replacement part kit instructions
K Air consumption per shot @ 5.6 Bar
L Activation type
M Summer lubricant
N Winter lubricant
O O-ring lubricant
P Fastener Name
Q Dimensions mm.
R Head/crown
S Magazine capacity
T New Driver Length mm.
U Max. Depth Inside Piston mm.
Service Interval
Daily
Daily
Daily
Daily
Weekly
25,000 Fasteners, or monthly -
if used in dusty location
25,000 Fasteners
50,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
500,000 Fasteners