Features; Product Specifications; Assembly; Unpacking - PowerStroke PS80903A Manual Del Operador

PRODUCT SPECIFICATIONS

Engine ...............................................................................................................................................................Honda GC160
Fuel Tank Capacity ..................................................................................................................................................... 0.48 gal
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,600 psi
Maximum Gallons Per Minute* ...................................................................................................................................2.3 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101, when tested with red nozzle
KNOW yOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ENGINE SWITCH
The engine switch is used in combination with the recoil
starter grip to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.48 gal. Use
unleaded automotive gasoline in the engine.
HONDA GC160 ENGINE
This Honda engine enables the pressure washer to achieve
2,600 psi (pounds per square inch) at a rate of 2.3 gpm
(gallons per minute). Please read the engine manual included
with this product.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the back of
the machine using the stretch strap to secure in place.

UNPACKING

This product requires assembly.
 Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
WARNING:
This new product has been shipped in a partially as-
sembled condition as described below. Carefully check
the packing list below to ensure all items are included in
the package; the packing list describes all loose items
that are not assembled to the product as shipped. Do not
operate the product if any packing list items are already
assembled to your product when you unpack it. Call the
customer service number below for assistance. Opera-
tion of a product that may have been improperly preas-
sembled could result in serious personal injury.
All manuals and user guides at all-guides.com

FEATURES

RECOIL STARTER
The recoil starter is pulled to start the machine.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
THERMAL RELEASE VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of
water. Once the water has drained, the thermal relief valve
will reset itself.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.

ASSEMBLy

 Inspect the tool carefully to make sure no breakage or
 Do not discard the packing material until you have care-
 If any parts are damaged or missing, please call
Page 7 — English
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
damage occurred during shipping.
fully inspected and satisfactorily operated the tool.
1-877-617-3501 for assistance.