Operation - PowerStroke PS80903A Manual Del Operador

ASSEMBLING THE TRIGGER HANDLE
See Figure 7.
To attach the spray wand:
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 Turn the connector clockwise until it stops. This
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 5.
 Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 8.
After the high pressure hose has been uncoiled and attached
to the spray wand:
 Align the collar on the threaded outlet on the pump.
 Insert the hose on the end of the high pressure hose collar
into the threaded outlet.
 Turn the collar clockwise to tighten the hose securely to
the pump.
 Pull on the hose to be certain it is properly secured.
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of
attachments or accessories not recommended can result
in serious personal injury.
All manuals and user guides at all-guides.com
ASSEMBLy
CONNECTING THE GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 9, page iv.
The water supply must come from a water main. NEVER
use hot water or water from pools, lakes, etc. Before
connecting the garden hose to the pressure washer:
secures
 Run water through the hose for 30 seconds to clean any
 Inspect the screen in the water intake.
 If the screen is damaged, do not use the machine until
 If the screen is dirty, clean it before connecting the garden
To connect the garden hose to the machine:
 Uncoil the garden hose.
 With the hose faucet turned completely off, attach the

OPERATION

APPLICATIONS
You may use this tool for the purposes listed below:
 Removing dirt and mold from decks, cement patios, and
 Cleaning cars, boats, motorcycles, outdoor furniture, and
Page 9 — English
debris from the hose.
the screen has been replaced.
hose to the machine.
NOTE: There must be a minimum of 10 feet of unre-
stricted hose between the pressure washer intake and
the hose faucet or shut off valve (such as a "Y" shut off
connector).
end of the garden hose to the water intake. Tighten by
hand.
WARNING:
Never direct a water stream toward people or pets, or
any electrical device. Failure to heed this warning could
result in serious injury.
house siding
grills