Safety Instructions; Intended Use; Noise / Vibration Information - Würth WIG 180 AC Traducción Del Manual De Instrucciones De Servicio Original

▸
Use the safety chain to secure the gas cylinder
against falling over.
▸
Remove the gas cylinder before transport.
▸
Pull the mains plug before moving the appliance
or performing work on the appliance.

Intended Use

The machine is designed to weld steel, alumin-
ium and alloys both in commercial and industrial
environments.
• The machine is used for DC TIG welding of:
— Unalloyed, low-alloy and high-alloy steels,
— Copper and its alloys,
— Nickel and its alloys,
— Special metals such as titanium, zirconium and
tantalum.
• For AC TIG welding of:
— Aluminium and its alloys,
— Magnesium and its alloys
and for electrode welding.
The user is solely responsible for damage
resulting from improper use.
Transport
Attention!
The carrying strap and handle are intended only
for transport by persons.
The machine must not be lifted by mechanical
means (e.g. crane, etc.).

Noise / vibration information

The noise emission measured in accordance with EN
60 974-1 at normal load and maximum operating
point is less than 70 dB(A).
18

Safety Instructions

▸
To mark the appliance, do not drill holes into the
casing and do not attach rivets. Use stickers.
▸
Use only genuine Würth accessories and
spare parts.
Check for compliance with provisions
stipulated in the German BGV
The operating company of commercially used
welding equipment is obliged to have the appliances
checked in accordance with directive EN 60974-4
at regular intervals appropriate for the frequency
of use. Würth recommends having the appliance
checked every 12 months.
Additional safety checks have to be performed after
modifying or repairing the appliance.
Improper checks for compliance with accident
prevention regulations may result in destruction of
the machine. Please contact an authorised Würth
service point for more information on checking the
compliance with accident prevention regulations.
1 Operating panel
2 Welding torch / electrode holder / workpiece
lead socket
3 Torch button
4 Welding torch gas connection
5 Workpiece lead /
electrode holder socket
6 Main switch
7 Mains lead connection
8 Shielding gas connection
9 Water cooling device connection WUK 6
10 Remote control socket
Attention!
Product features (Fig. I)