Sauder Edge Water 419401 Manual Del Usuario página 25

Step 20
Carefully turn your unit over onto its front edges. Lay the BACK (J)
å
over your unit.
Make equal margins along the bottom and both side edges of the
å
BACK (J). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACK (J) to your unit using the NAILS (1N). The
å
BACK (J) will overlap the LARGE BACK (I).
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELF (H).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
These holes must line up
over the SHELF (H).
www.sauder.com/services
J
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
I
419401
Caution
1N
NAIL
(28 used in this step)
Page 25