Sauder Edge Water 419401 Manual Del Usuario página 27

Step 22
Carefully stand your unit upright.
å
NOTE: You will need to use a Short Screwdriver in this step.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it
isn't, loosen the mounting screw to slide it against the stops.
Then tighten the mounting screw.
Fasten the DOOR (K) to the RIGHT UPRIGHT (C) as shown in
å
the lower diagram. Use the screws in the HINGES. You should
start each SCREW a few turns before completely tightening
any of them.
Fasten a KNOB (17K) and BACKPLATE (18K) to the DOOR (K).
å
Use a BLACK 1-1/8" MACHINE SCREW (21S).
See the next step for DOOR adjustments.
å
www.sauder.com/services
C
21S
BLACK 1-1/8" MACHINE SCREW
(1 used in this step)
419401
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
K
18K
17K
Page 27