Black 9/16" Large Head Screw - Sauder Edge Water 419401 Manual Del Usuario

Step 11
Carefully turn your assembly onto its TOP (E) and lay the
å
LARGE BACK (I) over your unit.
Make equal margins along all four edges of the LARGE
å
BACK (I). Push on opposite corners of your unit if needed
to make it "square".
Fasten the LARGE BACK (I) to the DIVIDERS (T). Use
å
three BLACK 9/16" LARGE HEAD SCREWS (1S). Then,
fasten the remainder of the LARGE BACK to your unit
using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up
å
over the HUTCH UPRIGHT (P).
Curved edge
E
Page 16
Cut-out
O
These holes must line up over
the HUTCH UPRIGHT (P).
419401
1N
NAIL
(33 used in this step)
I
e
f a c
s u r
e d
n i s h
U n fi

BLACK 9/16" LARGE HEAD SCREW

(3 used for the DIVIDERS)
www.sauder.com/services
1S