Maintenance; General Maintenance - Ryobi RY803111 Manual Del Operador

MOVING THE PRESSURE WASHER
See Figure 23.
NOTE: Never lift or carry this product using the handle and
never place the unit in any position other than upright on its
wheels.
 Turn the pressure washer off and ensure fuel valve is
CLOSED.
Normal maintenance, replacement or repair of emission con-
trol devices and systems may be performed by any qualified
repair establishment or individual with original or equivalent
parts. Warranty and recall repairs must be performed by an
authorized service center; please contact customer service
for assistance.
WARNING:
Before inspecting, cleaning, or servicing the machine, shut
off engine, wait for all moving parts to stop, and discon-
nect spark plug wire and move it away from spark plug.
Failure to follow these instructions can result in serious
personal injury or property damage.
WARNING:
Always remove the battery pack and keep hands clear of
the engine switch when transporting, assembling parts,
making adjustments, cleaning, or when not in use. Fol-
lowing these instructions will prevent accidental starting
that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create a
hazard or cause product damage.
All manuals and user guides at all-guides.com
OPERATION
 Tilt the machine toward you slightly until it balances on
 DO NOT attempt to move the unit by pulling on any of the

MAINTENANCE

NOTICE:
This product is not equipped with a spark arrestor and
cannot be used on U.S. forest lands; in addition, product
users must comply with Federal, State, and local fire
prevention regulations. Check with appropriate authorities.
NOTICE:
Periodically inspect the entire product for damaged, miss-
ing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not oper-
ate this product until all missing or damaged parts are
replaced. Please contact customer service or a qualified
service center for assistance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage, weaken or destroy
plastic which could result in serious personal injury.
Before running the engine, perform the following pre-operation
steps:
 Check that all bolts, nuts, etc., are securely tightened.
 Make sure the air filter is clean.
 Check both the engine lubricant level and the fuel tank
 Inspect the work area for hazards.
 If there is excessive noise or vibration, stop the unit
Page 15 — English
the wheels then roll the machine to the desired position.
Do not tilt forward or sideways when moving.
hoses.
WARNING:
level; refill as needed.
immediately.