Adding Gasoline To The Fuel Tank; Electric Start - Ryobi RY803111 Manual Del Operador

ETHANOL-BLENDED FUELS
NOTICE:
Do not use E15 or E85 fuel in this product. It is a
violation of federal law and will damage the unit
and void your warranty. Only use unleaded gasoline
containing up to 10% ethanol.

ADDING GASOLINE TO THE FUEL TANK

See Figure 10.
DANGER:
Risk of fire and serious burns: Never remove fuel cap
when unit is running. Shut off engine and allow the unit to
cool at least five minutes. Remove cap slowly.
WARNING:
Gasoline and its vapors are highly flammable and
explosive. To prevent serious personal injury and property
damage, handle gasoline with care. Keep away from
ignition sources, handle outdoors only, do not smoke while
adding fuel, and wipe up spills immediately.
WARNING:
Always shut off engine before fueling. Never remove fuel
cap or add fuel to a machine with a running or hot engine.
Make sure the unit is sitting on a flat, level surface and
only add fuel outdoors. If the engine is hot, let the unit cool
for at least five minutes before adding fuel. After fueling,
immediately replace fuel cap and tighten securely. Move
at least 30 ft. from refueling site before starting engine. Do
not smoke and stay away from open flames and sparks!
Failure to follow these instructions could result in a fire
and cause serious personal injury.
WARNING:
Check for fuel leaks. A leaking fuel cap, tank, or line is a
fire hazard and must be replaced immediately. If you find
any leaks, correct the problem before using the product.
Failure to do so could result in a fire that could cause
serious personal injury.
All manuals and user guides at all-guides.com
OPERATION
NOTE: This is a 4-cycle engine. DO NOT mix fuel and
lubricant together.
 Turn the fuel valve to the CLOSED position.
 Mix fuel stabilizer with gasoline according to fuel stabilizer
 Before removing the fuel cap, clean the area around it.
 Insert a clean funnel into the fuel tank then slowly pour
 Replace fuel cap and tighten securely.
 Clean up any spills before starting the engine.

ELECTRIC START

This pressure washer model is provided with both electric
start and recoil start capabilities. Avoid prolonged cranking,
as it can damage the engine. The electric start feature can
only be used when a sufficiently charged RYOBI
battery pack is installed.
For complete charging instructions, refer to the Operator's
Manuals for your RYOBI
models.
Always remove the battery pack and keep hands clear
of the engine switch when transporting, assembling
parts, making adjustments, cleaning, or when not in
use. Following these instructions will prevent accidental
starting that could cause serious personal injury.
TO INSTALL BATTERY PACK
See Figure 11.
 Open the battery cover.
 Insert the battery pack into the battery port as shown.
Make sure the latches on the battery pack snap in place
and the battery pack is fully seated and secure in the bat-
tery port before beginning operation. Failure to securely
seat the battery pack could cause the battery pack to fall
out, resulting in serious personal injury.
 Close the battery cover.
Page 11 — English
manufacturer's directions.
Remove the fuel cap.
gasoline into the tank. Fill tank to approximately 1-1/2 in.
below the top of the tank neck (this allows for fuel
expansion).
One+
™
WARNING:
WARNING:
One+
™
battery pack and charger
™
™